Agilent Technologies 35670A Manual page 376

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

The <select_code> and <unit_number> specified with the MMEM:MSIS command

becomes the default disk and unit address for the external disk drive (EXT:).

DOS_DIR specifies a directory name (DOS only). DOS directory names are limited to ASCII characters. The

forward slash (/) may be used as a directory separator instead of the backward slash (\). The brackets are not

literal in the parameter. They indicate that the directory designation is optional. If the director is not

specified, the default directory is used. Select the default specifier with the MMEM:MSIS command.

The valid character set for <FILENAME> depends on the disk format.

DOS file names are limited to 8 ASCII characters followed by a period and a three character extension. The

period and extension are not required. File names are not case sensitive.

LIF file names are limited to 10 character which may include any character except ":" "," and "|". The first

character must be a letter. File names are case sensitive.

<MSINAME> ::=

This parameter specifies the mass storage device. It takes one of the following values:

The brackets are not literal in the parameter. They indicate that the external disk drive's address is optional.

If the <select_code> and <unit_number> are not specified, the analyzer uses the default values specified with

the MMEM:MSIS command.

<MMEMNAME> ::=

This parameter specifies a single file or an entire mass storage device. It takes the same form as

<FILENAME> except either the name of the file, the name of the mass storage device or both must be

present. It can take one of the following forms:

See the description for <FILENAME> for the valid mass storage device specifiers and the valid file name

character set.

'EXT[,<select_code>[,<unit_number>]]:'

'[MSIS:][DOS_DIR:]filename'

'MSIS:[DOS_DIR:]filename'