Calculate[1|2|3|4]:Cfit[:Immediate]Command; Display[:Window[1|2|3|4]]:Trace:label:default[:State]Command/Query - Agilent Technologies 35670A Manual

This section provides instrument-specific information for the operation of the Agilent 35670A in an GPIB
system. For a general overview of how an analyzer operates in an GPIB system, see the GPIB
Programmer's Guide.
The Agilent 35670A can be configured as an GPIB system controller or as an addressable-only GPIB
device. To configure the analyzer, press the [ Local/GPIB ] key on the front panel. To configure the
analyzer as the GPIB system controller press [
configure the Agilent 35670A as an addressable-only device on the bus, press [
Normally, the Agilent 35670A is not configured as the system controller unless it is the only controller on
the bus. Such a setup would be likely if you only wanted to control printers or plotters with the analyzer.
It might also be the case if you were using Instrument BASIC to control other test equipment.
When the analyzer is used with another controller on the bus, it is normally configured as an
addressable-only GPIB device. In this configuration, when the analyzer is passed control it can function
as the active controller. It can also function as a talker or listener.
If there is more than one controller on the bus, the Agilent 35670A needs to have active control (instead
of system control) to initiate operations such as plotting. The Agilent 35670A must be the active
controller for the following GPIB commands:
HCOPy[:IMMediate]
HCOPy:ITEM:ALL[:IMMediate]
HCOPy:ITEM[:WINDOW[1|2|3|4]]:TRACe:GRATicule[:IMMediate]
HCOPy:ITEM[:WINDOW[1|2|3|4]]:TRACe[:IMMediate]
HCOPy:ITEM[:WINDOW[1|2|3|4]]:TRACe:MARKer[:IMMediate]
HCOPy:ITEM[:WINDOW[1|2|3|4]]:TRACe:MARKer:REFerence[:IMMediate]
MMEMory:COPY
MMEMory:DELete
MMEMory:INITialize
MMEMory:MSIS
MMEMory:MOVE
See the GPIB Programmer's Guide, for more information and examples about passing control to an
analyzer.
1-8
] which appears in the softkey menu. To
].