Agilent Technologies 35670A Manual page 542

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude]

Specifies the source output level.

Command Syntax:

<number> ::= a real number (NRf data)

<unit> ::= [DBVRMS|VPK|DBVPK|V|DBV|VRMS]

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

The source output level can be expressed in terms of peak values, Vpk, or rms values, Vrms.

While most source waveforms are limited to a maximum of 5 VPK, pink noise (SOUR:FUNC PINK) is

limited to 4.196 VPK. The minimum is 0 VPK. If the source output level is specified in DBVRMS, the

smallest non-zero level is -74.912 DBVRMS.

To determine if the output level is set to PEAK, PP (peak-to-peak), or RMS values, send SOUR:VOLT?

UNIT. Each source waveform has a specific peak-to-rms value. The maximum rms level depends upon

the source waveform. See Online Help for additional information.

SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude] {<number>

[<unit>]}|<step>|<bound>

-9.9e37:13.9794

OUTPUT 711;"SOUR:VOLT 0 DBV"

OUTPUT 711;"sour:volt:lev:imm:amp 5 VPK"

SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude]?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

command/query