Agilent Technologies 35670A Manual page 320

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

HCOPy:DEVice:SPEed

Specifies the plotting speed for all plotting operations initiated by the analyzer.

Command Syntax:

<number> ::= a real number (NRf data)

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command allows you to specify the plotting speed in units of centimeters per second (cm/s). Check

your plotter's documentation to be sure that it supports the requested plotting speed.

For example, send HCOP:DEV:SPE 75 to select a plotting speed of 75 cm/second. Send

HCOP:DEV:SPE 10 to select a slower plotting speed of 10 cm/second. HCOP:DEV:SPE 0 selects the

plotter's default plot speed.

HCOPy:DEVice:SPEed <number>|<step>|<bound>

OUTPUT 711;"HCOP:DEV:SPE 53"

OUTPUT 711;"hcopy:device:speed 0"

HCOPy:DEVice:SPEed?

not applicable

Synchronization Required:

Preset State:

+0 (plotter's default speed)

SCPI Compliance:

command/query