Agilent Technologies 35670A Manual page 639

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

TRIGger:SLOPe

Specifies the slope of the signal which triggers the analyzer.

Command Syntax:

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

The analyzer is triggered either by a low-to-high transition of the trigger signal (POS) or by the

high-to-low transition of the trigger signal (NEG).

Use the TRIG:LEV or TRIG:EXT:LEV command to specify the trigger level.

This command is only valid with the following selections:

TRIG:SOUR:EXT

TRIG:SOUR:INT1

TRIG:SOUR:INT2

TRIG:SOUR:INT3

TRIG:SOUR:INT4

The query returns the currently specified slope.

TRIGger:SLOPe POSitive|NEGative

OUTPUT 711;"Trigger:Slop POSITIVE"

OUTPUT 711;"TRIGGER:SLOP NEGATIVE"

TRIGger:SLOPe?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

command/query