Agilent Technologies 35670A Manual page 441

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

[SENSe:]AVERage:COUNt

Specifies a count or a weighting factor for the averaged measurement data.

Command Syntax:

<number> ::= a real number (NRf data)

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

As a counter, AVER:COUN determines the number of time records used to average the measurement

data. This command is only valid in FFT, order analysis and correlation instrument modes.

Once the specified number of time records have been averaged, the No Pending Operation (NPO) flag is

set to 1. Use the *OPC command to determine when the specified number of time records have been

combined. (See "Synchronization" in the GPIB Programmer's Guide for more information about the

completion of averaged measurements.)

When used with exponential averaging (AVER:TYPE RMS;TCON EXP or AVER:TYPE TIME;TCON

EXP), this command determines how the results of the current measurement (new data) is combined with

the averaged trace (old data). Data is combined, point by point, according to the following formula:

[SENSe:]AVERage:COUNt <number>|<step>|<bound>

OUTPUT 711;"sense:average:count 2"

OUTPUT 711;"AVER:COUN 100"

[SENSe:]AVERage:COUNt?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

command/query