Agilent Technologies 35670A Manual page 398

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

MMEMory:MSIS

Specifies a default disk.

Command Syntax:

<MSINAME> ::= '<disk>'|"<disk>"

<disk> ::= NVRAM:|RAM:|INT:|EXT[,<select_code>[,<unit_number>]]:

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

If you omit disk specifiers from MMEMory commands, the commands are automatically directed to the

default disk. This command uses the following mnemonics to select the default disk:

NVRAM: — selects the non-volatile RAM disk.

RAM: — selects the volatile RAM disk.

INT: — selects the internal disk.

EXT: — selects the external disk. The select code and unit number specifiers are valid only with

the EXT: disk specifier. If the select code and unit number are specified with this command, they

become the default for all external disks (EXT:) specifiers.

To determine the type of file system for the default disk, send the MMEM:FSYStem? query.

When accessing the external mass storage device (EXT:); the active controller on the

GPIB must temporarily pass control to the analyzer. After the command has been

executed, the analyzer must pass control back. See the GPIB Programmer's Guide for

more information on passing control.

MMEMory:MSIS <MSINAME>

OUTPUT 711;":Mmem:Msis 'INT:'"

OUTPUT 711;"MMEMORY:MSIS 'RAM:'"

MMEMory:MSIS?

"NVRAM:"|"RAM:"|"INT:"|"EXT:"

not applicable

Synchronization Required:

Preset State:

saved in non-volatile memory

SCPI Compliance:

command/query