Agilent Technologies 35670A Manual page 394

MMEMory
MMEMory:LOAD:TRACe
Loads a trace into the analyzer from the specified disk.
Command Syntax:
<FILENAME> ::= '[<PATH>]<filename>'
<PATH> ::= <MSIS>[{DOS_DIR}]
<MSIS> ::= RAM:|NVRAM:|INT:|
<DOS_DIR> ::= \<DIR_NAME>\
<DIR_NAME> ::= ASCII characters
<filename> ::= ASCII characters (see beginning of chapter
Example Statements:
Attribute Summary:
Description:
This command loads the contents of a file into one of the analyzer's eight data registers (D1 through D8).
The first parameter specifies the destination. The second parameter specifies the source.
The optional parameter, <NOSCALE>, specifies the scaling of the trace. If NOSCALE is not included,
the data register is scaled to match the scaling of the trace when it was saved to the file. If the NOSCALE
parameter is included, the current scaling of the data register is not modified. This parameter is not
compatible with SCPI.
The file must have been saved with the MMEM:STOR:TRAC command. After loading the data register
you can display its contents with the CALC:FEED 'D{1|2 . . . |8}' command.
15-20
MMEMory:LOAD:TRACe {D1|D2|D3|D4|D5|D6|D7|D8}, <FILE-
NAME>[,<NOSCALE>]
EXT[,<select_code>[,<unit _number>]]:
(DOS only)
for <filename> restrictions)
OUTPUT 711;"MMEM:LOAD:TRAC D4, 'MYTRACE'"
OUTPUT 711;"mmem:load:trace D5, 'int:testtr'"
Option: not applicable
Synchronization Required:
Preset State: not applicable
SCPI Compliance:
no
confirmed
command