Agilent Technologies 35670A Manual page 499

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

[SENSe:]SWEep:DWELl

Specifies the integration time for swept sine measurements.

Command Syntax:

<dwell_time> ::= {<number>[<unit>]}|<step>|<bound>

<number> ::= a real number (NRf data)

<unit> ::= [S|CYCLE]

<step ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

Integration time is the amount of time that each point is measured.

Sending SWE:DWEL in seconds, results in a constant integration scale.

Sending SWE:DWEL in cycles, results in a proportional integration scale. At higher frequencies the

same number of cycles occurs in a shorter time. The integrate time must be a minimum of 1 cycle long.

The analyzer takes any value less than one as one complete cycle.

[SENSe:]SWEEP <dwell_time>

250e-6:32768 S

OUTPUT 711;"sense:sweep:dwel .005 s"

OUTPUT 711;"Swe:Dwell 1 cycle"

[SENSe:]SWEep:DWELl?

1D2 Swept Sine

Synchronization Required:

Preset State:

SCPI Compliance:

command/query