Calculate[1|2|3|4]:Synthesis:gaincommand/Query - Agilent Technologies 35670A Manual

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

CALCulate[1|2|3|4]:CFIT:FREQuency:STOP

Specifies the stop frequency for a curve fit operation over a limited frequency span.

Command Syntax:

<number> ::= a real number (NRf data

<unit> ::= [HZ]

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command is not valid unless the CALC:CFIT:FREQ OFF command has been sent.

This command is not trace specific. It ignores the trace specifier.

CALCulate[1|2|3|4]:CFIT:FREQuency:STOP {<num-

ber>[<unit>]}|<step>|<bound>

0.390625:115000.0

OUTPUT 711;":Calculate:Cfit:Freq:Stop 1.2 khz"

OUTPUT 711;"CALC:CFIT:FREQ:STOP 800"

CALCulate[1|2|3|4]:CFIT:FREQuency:STOP?

1D3 Curve Fit/Synthesis

Synchronization Required:

Preset State:

SCPI Compliance:

instrument-specific

command/query