Agilent Technologies 35670A Manual page 452

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

[SENSe:]AVERage:TCONtrol

Specifies how the analyzer behaves after the count (AVER:COUN) is reached.

Command Syntax:

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command specifies termination control during averaging.

To specify linear (normal) averaging, send TCON FRE with the AVER:TYPE command.

To specify exponential averaging, send TCON EXP with the AVER:TYPE command.

To specify repeat averaging ("autostart"), send TCON REP with the AVER:TYPE command. The

analyzer takes N averages, clears the data, waits for arming conditions, and then takes another N

averages. The analyzer continues taking measurements until you send one of the following commands:

INIT:CONT OFF

AVER:STAT OFF

AVER:TCON FRE

Depending upon the instrument mode (specified with the INST:SEL command), some types of

termination control and averaging are not valid. See table 18-1.

[SENSe:]AVERage:TCONtrol FREeze|REPeat|EXPonential

OUTPUT 711;"Sense:Aver:Tcon FREEZE"

OUTPUT 711;"AVERAGE:TCON REPEAT"

[SENSe:]AVERage:TCONtrol?

not applicable

Synchronization Required:

Preset State:

not applicable

SCPI Compliance:

command/query