Agilent Technologies 35670A Manual page 475

[SENSe:]FREQuency:RESolution:AUTO:MINimum
Specifies the initial resolution of a swept sine measurement with automatic resolution.
Command Syntax:
<number> ::= a real number (NRf data)
<unit> ::= [HZ|PCT|PNT/SWP|PNT/DEC|PNT/OCT]
<step> ::= UP|DOWN
<bound> ::= MAX|MIN
Example Statements:
Query Syntax:
Return Format:
Attribute Summary:
Description:
If automatic resolution is specified (FREQ:RES:AUTO ON), this command sets the initial resolution used
between the first and second measurement point. It also specifies the minimum resolution the analyzer
uses if an adjustment in resolution is required.
The analyzer calculates the ratio of the frequency response of the current measurement point to the
frequency response of the previous measurement point. If the ratio exceeds the specified limit
(FREQ:RES:AUTO:MCH), the analyzer corrects the resolution and applies it to the next measurement
point. The correction is never less than the value specified by this command.
If linear spacing is specified (SWE:SPAC LIN), the resolution can be set using the following units:
HZ hertz
PNT/SWP points per sweep
PCT spacing between measurement points as a percentage of the total frequency span
If logarithmic spacing is specified (SWE:SPAC LOG), the resolution can be set using the following units:
PNT/SWP points per sweep
PNT/DEC points per decade
PNT/OCT points per octave
PCT spacing between measurement points as a percentage of the total frequency span
To determine what the current unit setting is, send FREQ:RES? UNIT.
[SENSe:]FREQuency:RESolution:AUTO:MINimum {<number>
[<unit>]}|<step>|<bound>
limits: 0.015625:51200.0
OUTPUT 711;"sense:freq:resolution:auto:minimum 10 hz"
OUTPUT 711;"FREQ:RES:AUTO:MIN 200 PNT/SWP"
[SENSe:]FREQuency:RESolution:AUTO:MINimum?
Real
Option: 1D2 Swept Sine
Synchronization Required:
Preset State: 401 PNT/SWP
SCPI Compliance:
no
instrument-specific
[SENSe:]
command/query
18-37