Agilent Technologies 35670A Manual page 463

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

[SENSe:]DATA:RANGe

Specifies range value for the time capture data.

Command Syntax:

<number> ::= a real number (NRf data)

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command is used to set the range value for data transfered to the analyzer with the SENSE:DATA

command. The range must be set before time data is loaded into the capture buffers from a controller.

This value (in Volts or EUs) is used to convert the data into the integer format used by the analyzer. To

get full 16 bit accuracy, the value sent should be the same as the largest data value to be loaded.

Any data values larger than the range value will be clipped.

[SENSe:]DATA:RANGe TCAP1|TCAP2|TCAP3|TCAP4, <number>

limits: 1.0E-20 − 1.0E20

OUTPUT 711;"SENSE:DATA:RANGE TCAP1, 1.5e+3"

[SENSe:]DATA:RANGE? TCAP1|TCAP2|TCAP3|TCAP4

Option: not applicable

Synchronization Required: no

Preset state: 0

SCPI Compliance: instrument-specific

command/query