Agilent Technologies 35670A Manual page 513

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

[SENSe:]TCAPture:STARt[1|2|3|4]

Specifies the beginning of the time capture data used in a measurement.

Command Syntax:

<number> ::= a real number (NRf data)

<unit> ::= [S|BLK|PNT]

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command allows to select a portion of the time capture data to be used for the measurement. You

can set the "analysis region" for each channel independently.

Use the TCAP:STOP command to specify the end of the time capture data.

The analyzer sets this value to the beginning of the capture data upon receiving any of the following

MMEMory:LOAD:STATe

MMEMory:LOAD:TCAPture

[SENSe:]TCAPture[:IMMediate]

SYSTem:PRESet

[SENSe:]TCAPture:STARt[1|2|3|4] {<num-

ber>[<unit>]}|<step>|<bound>

-9.9e37:9.9e37

OUTPUT 711;"Sens:Tcap:Star 1 mS"

OUTPUT 711;"TCAPTURE:START 3 BLK"

[SENSe:]TCAPture:STARt[1|2|3|4]?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

instrument-specific

command/query