Agilent Technologies 35670A Manual page 230

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

This command is valid for all measurement data selections in the FFT, swept sine and correlation

instrument modes. It is also valid for time data in the histogram instrument mode. It is not available for

measurement data selections in the octave analysis nor the order analysis instrument modes.

The X-axis unit is applied to the specified trace. Omit the specifier or send CALC1 for trace A, CALC2

for trace B, CALC3 for trace C, or CALC4 for trace D.

The X-axis unit setting applies to the measurement data selection independent of the instrument mode.

For example, if you specify the X-axis unit for time data in the FFT instrument mode, that X-axis unit is

applied to time data in the correlation instrument mode as well.

The X-axis unit is not applied to measurement data stored in any of the analyzer's registers (data,

waterfall or math). To set the X-axis unit for measurement data stored in a register, display the register

data in one of the trace boxes. Send the command specifying that trace.