Calculate[1|2|3|4]:Synthesis:copycommand - Agilent Technologies 35670A Manual

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

CALCulate[1|2|3|4]:CFIT:DATA

Loads values into the curve fit table.

Command Syntax:

<BLOCK> ::= see Description

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command transfers a complete curve fit table from your controller to the analyzer.

When you transfer a curve fit table to the analyzer, you must use the definite length block syntax. Data

must be 64-bit binary floating-point numbers (see the FORMat[:DATA] REAL command). The elements

of the definite length block for a curve fit table are defined below.

The first point specifies the table type; followed by three points which specify the size of the table. Th

next 80 points are the complex pairs. The remaining points are descriptors. Points 152 - 174 indicate

which terms are fixed. Points 173 - 175 are adjusters; gain, frequency scale and time delay.

See "Block Data" in the GPIB Programmer's Guide for additional information about transferring block

This command is not trace specific. It ignores the trace specifier.

CALCulate:CFIT:DATA <BLOCK>

OUTPUT 711;":CALCULATE:CFIT:DATA BLOCK"

OUTPUT 711;"calc:cfit:data BLOCK"

CALCulate[1|2|3|4]:CFIT:DATA?

1D3 Curve Fit/Synthesis

Synchronization Required:

Preset State:

not applicable

SCPI Compliance:

instrument-specific

command/query