Agilent Technologies 35670A Manual page 238

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

For polar diagrams (CALC:FORM POL) the block is a series of magnitude and phase pairs

(<1st_trace_1st_magnitude_value>, <1st_trace_1st_phase_value>, . . .

<last_trace_last_magnitude_value>, <last_trace_last_phase_value>).

In octave analysis instrument mode (INST:SEL OCT;Option 1D1) the second to the last value in the trace

data is the weighted overall band. The last value in the trace data is the overall band. These values (for

each trace) are included in the data block, even if they are not displayed.

Use the CALC:X:DATA? query to determine the X-axis values for the waterfall data. Use the

TRACe:Z[:DATA]? query to determine the Z-axis values for the waterfall data.

This query has no command form. You cannot return waterfall data to the display with

CALC:WAT:DATA. To send data that has not been transformed, use the TRAC:WAT[:DATA]

command. See the introduction to this chapter for more information about the differences between these