Agilent Technologies 35670A Manual page 226

CALCulate
CALCulate[1|2|3|4]:UNIT:MECHanical
Converts the Y-axis trace coordinates from the input's transducer units to the selected engineering units
on the display.
Command Syntax:
<UNIT> ::= 'G'|"G"
Example Statements:
Query Syntax:
Return Format:
Attribute Summary:
Description:
The analyzer integrates or differentiates the displayed trace coordinates to convert the display to the
specified unit.
The trace specifier, CALCulate[1|2|3|4], determines which trace you are selecting. Omit the specifier or
send 1 for trace A, 2 for trace B, 3 for trace C, or 4 for trace D.
Note
This command is only valid when the transducer units are G's, m/S
inch/S, inch, or mils. See the SENSE:VOLTAGE:DC:RANGE:UNIT:XDCR:LABEL
command for information about setting transducer units.
6-118
CALCulate [1|2|3|4]:UNIT:MECHanical <UNIT>
'M/S2'|"M/S2"
'M/S'|"M/S"|
'M'|"M"
'INCH/S2'|"INCH/S2"
'INCH/S'|"INCH/S"
'INCH'|"INCH"
'MILS'|"MILS"
OUTPUT 711;"CALC2:UNIT:MECH 'M/S'"
OUTPUT 711;"calculate:unit:mechanical:volt 'mils'"
CALCulate[1|2|3|4]:UNIT:MECHanical?
"G"|"M/S2"|"M/S"|"M"|"INCH/S2"|"INCH/S"|"INCH"|"MILS"
Option: not applicable
Synchronization Required:
Preset State: not applicable
SCPI Compliance:
yes
instrument-specific
command/query
2
, m/S, m, inch/S,