Agilent Technologies 35670A Manual page 411

MMEMory:STORe:TRACe
Saves the specified trace to a file on the specified disk.
Command Syntax:
<FILENAME> ::= '[<PATH>]<filename>'
<PATH> ::= <MSIS>[{DOS_DIR}]
<MSIS> ::= RAM:|NVRAM:|INT:|
<DOS_DIR> ::= \<DIR_NAME>\
<DIR_NAME> ::= ASCII characters
<filename> ::= ASCII characters (see beginning of chapter
Example Statements:
Attribute Summary:
Description:
The first parameter specifies which trace you are saving—TRAC1 for the trace appearing in trace box A,
TRAC2 for the trace appearing in trace box B, TRAC3 for the trace appearing in trace box C, and TRAC4
for the trace appearing in trace box D. The second parameter specifies the disk and filename. If the disk
is not specified, the file is saved to the default disk.
If the filename you specify matches the name of another file on the disk, this command overwrites the old
file.
This command differs from the TRAC:DATA command as the MMEM:STOR:TRAC command only
saves trace data to a file. TRAC:DATA saves trace data to one of the data registers.
Note
If you plan to transfer this file to a PC, refer to the MMEM:STOR:TRAC:FORM
command.
MMEMory:STORe:TRACe {TRACe1|TRACe2|TRACe3|TRACe4}, <FILE-
NAME>
EXT[,<select_code>[,<unit _number>]]:
(DOS only)
for <filename> restrictions)
OUTPUT 711;"mmem:stor:trace D5, 'int:testtr'"
OUTPUT 711;"MMEM:STORE:TRAC D4, 'MYTRACE'"
Option: not applicable
Synchronization Required:
Preset State: not applicable
SCPI Compliance:
no
confirmed
MMEMory
command
15-37