Quick Verification; Input[1|2|3|4][:State]Command/Query; Calculate[1|2|3|4]:Cfit:frequency:startcommand/Query; Display[:Window[1|2|3|4]]:Trace:bpower[:State]Command/Query - Agilent Technologies 35670A Manual

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

Having just completed all the steps in the preceding section, you are ready to verify that commands can

be sent over the GPIB. In this quick verification, you are going to enter an BASIC keyword that should

place the Agilent 35670A under remote control.

Type the following on the computer:

then press the computer's ENTER key. The RMT indicator should appear highlighted at the top of

the Agilent 35670A's screen (see figure 1-4). This tells you that the analyzer is under remote

control of the computer.

Remote Indicator

Now type the following on the computer:

then press the computer's ENTER key. The RMT indicator should become "ghosted." That is, the

word is still readable, but no longer highlighted. This tells you that the analyzer has been returned

to front-panel control.