Table of Contents
Advertisement
Program Installation
The adjustment program must be installed in the computer using the following procedures.
The installation can be divided into two stages, \Making a Working Copy" and \De ning the
Con guration".
Making a Working Copy
Copy the contents of the adjustment program disk to a working disk or to the harddisk to
prevent the program les from accidental deletion or destruction. Use the working disk or the
harddisk and store the original disk in a safe place.
De ning the Con guration
De ne the con guration of the adjustment equipment. The con guration includes the type and
the GPIB address of the multimeter to be used. Because the program depends on equipment
con guration, it must be rede ned if the equipment con guration has changed.
Refer to the following procedure to de ne the con guration.
1. Turn on the computer and bring up the BASIC system.
2. Set the Mass Storage Unit Speci er to the drive/directory where the adjustment program
exists using the MSI command.
3. Load the \ TE_A4263B " le from the adjustment program disk by pressing
LOAD "TE_A4263B"
4. Run the loaded program by pressing RUN .
5. As the program instructs, select the type of the multimeter to be used and enter its GPIB
address.
Note
Once the multimeter type and GPIB addresses are set, they cannot be changed
unless the con guration is rede ned.
Program Execution
Perform the following steps to start the adjustment program.
Note
Install the program prior to execution. Refer to \Program Installation".
1. Turn on the computer and bring up the BASIC system. Refer to the Table 1-2 for the
required language extensions.
2. Set the Mass Storage Unit Speci er to the drive/directory where the adjustment program
exists using the MSI command.
3. Load the program, \ ADJ4263B " by pressing LOAD "ADJ4263B"
4. Execute the program by pressing RUN .
(or
).
4
Return
5
4
Enter
5
(or
).
4
Return
5
4
Enter
5
Adjustments
2-5
Advertisement
Table of Contents
