Calculate[1|2|3|4]:Unit:x:user:frequency:factorcommand/Query - Agilent Technologies 35670A Manual

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

CALCulate[1|2|3|4]:FORMat

Selects a coordinate system for displaying measurement data and for transferring coordinate transformed

data to a controller.

Command Syntax:

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

To select a coordinate system that displays linear magnitude data along the Y-axis, send CALC:FORM

To display linear magnitude data on a logarithmic Y-axis scale, send CALC:FORM

MLIN;:DISP:TRAC:Y:SPAC LOG.

To select a coordinate system that displays logarithmic magnitude data on a linear Y-axis scale, send

CALC:FORM MLOG.

To select a coordinate system that displays wrapped phase along the Y-axis, send CALC:FORM PHAS.

Phase wraps at the display boundaries. If you change the display boundaries with the

DISP:WIND:TRAC:Y:TOP and DISP:WIND:TRAC:Y:BOTTOM commands, you change where phase

wraps on the display.

To select a coordinate system that displays imaginary numbers along the Y-axis, send CALC:FORM

IMAG. This coordinate system shows the imaginary component of complex data at each point along the

X-axis. If the data point is real rather than complex, a value of 0 is displayed for all X-axis points.

To select a coordinate system that displays real numbers along the Y-axis, send CALC:FORM REAL.

This coordinate system shows real data or the real component of complex data at each point along the

X-axis. This and the polar diagram (CALC:FORM POLar) are the only valid selection for orbit displays

(CALC:FEED 'XVOL:VOLT 1,2'). CALC:FORM REAL is the default selection for orbit displays.

CALCulate[1|2|3|4]:FORMat

|GDELay|POLar

OUTPUT 711;"CALC3:FORMAT IMAGINARY"

OUTPUT 711;"calc4:format IMAGINARY"

CALCulate[1|2|3|4]:FORMat?

not applicable

Synchronization Required:

Preset State:

MLOG trace A and trace C

REAL trace B and trace D

SCPI Compliance:

command/query