Agilent Technologies 35670A Manual page 563

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

STATus:OPERation:PTRansition

Sets bits in the Operation Status positive transition register.

Command Syntax:

<number> ::= a real number (NRf data)

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

To set a single bit in the Operation Status positive transition register to 1, send the bit's decimal weight

with this command. To set more than one bit to 1, send the sum of the decimal weights of all the bits.

(The decimal weight of a bit is 2

All bits are initialized to 0 when the analyzer is turned on or when the STAT:PRES command is sent.

However, the current setting of bits is not modified when you send the *RST command.

See "Operation Status Register Set" in chapter 1 for a definition of bits in the register set. See

"Programming the Status System" in the GPIB Programmer's Guide for information about the role

of positive transition registers in register sets.

STATus:OPERation:PTRansition <number>|<bound>

OUTPUT 711;"status:operation:ptransition 1536"

OUTPUT 711;"STAT:OPER:PTR 2048"

STATus:OPERation:PTRansition?

not applicable

Synchronization Required:

Preset State:

not affected by Preset

SCPI Compliance:

, where n is the bit number.)

command/query