Agilent Technologies 35670A Manual page 83

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

Sets the state of the Power-on Status Clear flag.

Command Syntax:

<number> ::= a real number (NRf data)

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command lets you specify whether or not the Service Request enable register and the Event Status

enable register should be cleared (all bits reset to 0) at power-up.

The settings of the Service Request enable register and the Event Status enable register are saved in

nonvolatile memory when you turn the analyzer off. These settings can be recalled when you turn the

analyzer on, but only if the Power-on Status Clear (PSC) flag is reset to 0. When the PSC flag is set to 1,

the two enable registers are cleared at power-up. Use *PSC to specify the state of the PSC flag.

The number last specified with *PSC is saved in nonvolatile memory, so it is not affected when you turn

the analyzer off and on. It is also not affected by the *RST command.

If you want the analyzer to generate a service request at power-up, bit 7 of the Event Status enable

is reset to 0.

The query returns the current state of the PSC flag.

*PSC <number>|<bound>

-32767:32767

OUTPUT 711;"*PSC 1"

OUTPUT 711;"*ESE 1;*SRE 16;*PSC 0"

not applicable

Synchronization Required:

Preset State:

not affected by Preset

SCPI Compliance:

Common Commands

command/query

! Generate SRQ on