Calculate[1|2|3|4]:Marker:x:relativecommand/Query - Agilent Technologies 35670A Manual

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

Specifies the type of arming for the analyzer's trigger.

Command Syntax:

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

To select automatic arming send IMM. The analyzer waits for the hardware to settle and then waits for a

trigger signal (specified by TRIG:SOUR) before starting the measurement. When the measurement is

completed, the trigger is automatically re-armed.

To select manual arming send MAN. The analyzer waits for the hardware to settle then waits for the

ARM[:IMM] command, and then waits for a trigger signal before starting the measurement. The

ARM[:IMM] command must be sent to re-arm the trigger after the measurement is completed.

To select RPM step arming send RPM. The analyzer waits for the hardware to settle, waits for the next

RPM level to be reached, and then waits for the trigger signal before starting the measurement. See the

TRIGger:TACHometer commands for more information about using the analyzer's tachometer.

To select time step arming send TIM. The instrument waits for the hardware to settle, waits for a trigger

and starts the measurement by collecting the first time record. The analyzer then waits until the end of

the time step interval (specified by ARM:TIM) and waits for the trigger signal before collecting the next

time record. In waterfall displays, all waterfall traces are referenced from the start time. See figure 5-2.

ARM:SOURce IMMediate|MANual|RPM|TIMer

OUTPUT 711;":arm:sour MANUAL"

OUTPUT 711;"Arm:Sour MANUAL"

IMM|MAN|RPM|TIM

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

command/query