Agilent Technologies 35670A Manual page 221

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

CALCulate[1|2|3|4]:UNIT:ANGLe

Specifies the unit for phase coordinates.

Command Syntax:

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command is only valid when phase trace coordinates are specified (CALC:FORM PHAS or

CALC:FORM UPH).

To select phase units in degrees for the specified trace, send CALC:UNIT:ANGL DEGR. To select phase

units in radians for the specified trace, send CALC:UNIT:ANGL RAD.

The trace specifier, CALCulate[1|2|3|4], determines which trace you are selecting. Omit the specifier or

send 1 for trace A, 2 for trace B, 3 for trace C, or 4 for trace D.

CALCulate[1|2|3|4]:UNIT:ANGLe DEGRee|RADian

OUTPUT 711;"CALC:UNIT:ANGL DEGR"

OUTPUT 711;"calculate2:unit:angl rad"

CALCulate[1|2|3|4]:UNIT:ANGLe?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

command/query