Agilent Technologies 35670A Manual page 194

CALCulate
CALCulate[1|2|3|4]:MARKer:SIDeband:CARRier
Specifies the carrier frequency used for sideband markers and calculations.
Command Syntax:
<number> ::= a real number (NRf data)
<unit> ::= [HZ|ORD|CPM]
<step> ::= UP|DOWN
<bound> ::= MAX|MIN
Example Statements:
Query Syntax:
Return Format:
Attribute Summary:
Description:
To specify the number of sidebands, send the CALC:MARK:SID:COUN command.
To increment the carrier frequency value to the next largest point on the X-axis, send
CALC:MARK:SID:CARR UP.
To decrement the carrier frequency value to the next smallest point on the X-axis, send
CALC:MARK:SID:CARR DOWN.
You can also set the value with an expression. Send
CALC:MARK:SID:CARR (CALC:MARK:X?) to set the carrier frequency value to the current X-axis
marker value.
Note
When you shift the carrier frequency up or down, all the sideband markers shift up or
down by the same amount.
The query returns the value of the carrier frequency (in X-axis units) currently used for sideband markers
and calculations. The value is returned even if the sideband markers are not on.
To determine the X-axis units, send CALC:MARK:SID:CARR? UNIT.
6-86
CALCulate[1|2|3|4]:MARKer:SIDeband:CARRier {<number>
[<unit>]}|<step>|<bound>
limits: -9.9e37:9.9e37
OUTPUT 711;"CALC:MARK:SID:CAR 2200 HZ"
OUTPUT 711;"calculate3:marker:sideband:carrier 19.800e03
RPM"
CALCulate[1|2|3|4]:MARKer:SIDeband:CARRier?
Real
Option: not applicable
Synchronization Required:
Preset State: not applicable
SCPI Compliance:
no
instrument-specific
command/query