Agilent Technologies 35670A Manual page 390

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

MMEMory:LOAD:PROGram

Loads an Instrument BASIC program into the analyzer from a file on the specified disk.

Command Syntax:

<FILENAME> ::= '[<PATH>]<filename>'

<PATH> ::= <MSIS>[{DOS_DIR}]

<MSIS> ::= RAM:|NVRAM:|INT:|

<DOS_DIR> ::= \<DIR_NAME>\

<DIR_NAME> ::= ASCII characters

<filename> ::= ASCII characters (see beginning of chapter

Example Statements:

Attribute Summary:

Description:

This command loads an Instrument BASIC program into the selected program buffer.

To specify the active program buffer, send the PROG:NAME command before sending this command. If

a program buffer is not specified, the Instrument BASIC program loads into Program 1.

To load an Instrument BASIC program directly from your controller, use the

PROGram[:SELected]:DEFine command.

MMEMory:LOAD:PROGram <FILENAME>

EXT[,<select_code>[,<unit _number>]]:

for <filename> restrictions)

OUTPUT 711;"mmemory:load:program 'myprog'"

OUTPUT 711;"MMEM:LOAD:PROG 'INT:IBFILE'"

not applicable

Synchronization Required:

Preset State:

not applicable

SCPI Compliance:

instrument-specific