Agilent Technologies 35670A Manual page 241

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

CALCulate[1|2|3|4]:WATerfall:SLICe:SELect:POINt

Selects a waterfall slice by its display point value.

Command Syntax:

<number> ::= a real number (NRf data)

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command specifies the X-axis position for the waterfall slice by point number.

The number of points displayed along the X-axis depends upon the number of lines of resolution seet with

the [SENSe:]FREQuency:RESolution command. See table 6-8.

In correlation analysis the number of points displayed along the X-axis depends upon the resolution and

the windowing function. See table 6-8.

In histogram analysis, the number of points is determined by the number of bins (set with the

[SENS:]HIST:BINS command). The maximum number is 1024 points.

In octave analysis, the number of points is determined by the bandwidth of the filters. There are 11 points

for full octave, 33 points for 1/3 octave and 132 points for 1/12 octave.

In some cases the number of points is arbitrary. These include waterfall displays from order tracking or

from the arbitrary source.

See the CALC:WAT:SLICe:COPY command for information about saving a waterfall slice to a data

CALCulate[1|2|3|4]:WATerfall:SLICe:SELect:POINt <number>|

OUTPUT 711;"Calc:Waterfall:Slic:Sel:Point 816"

OUTPUT 711;"CALC4:WATERFALL:SLIC:SEL:POINT 1409"

CALCulate[1|2|3|4]:WATerfall:SLICe:SELect:POINt?

not applicable

Synchronization Required:

Preset State:

not applicable

SCPI Compliance:

instrument-specific

command/query