Agilent Technologies 35670A Manual page 392

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

MMEMory:LOAD:SYNThesis

Loads a synthesis table into the analyzer from a file on the specified disk.

Command Syntax:

<FILENAME> ::= '[<PATH>]<filename>'

<PATH> ::= <MSIS>[{DOS_DIR}]

<MSIS> ::= RAM:|NVRAM:|INT:|

<DOS_DIR> ::= \<DIR_NAME>\

<DIR_NAME> ::= ASCII characters

<filename> ::= ASCII characters (see beginning of chapter

Example Statements:

Attribute Summary:

Description:

This command loads a synthesis table into the curve fit buffer. The file must have been saved with the

MMEM:STOR:CFIT or MMEM:STOR:SYNT commands.

The current synthesis table is overwritten.

The file extensions ".FIT" and ".SYN" are naming conventions. The file type is created

with the MMEM:STOR:CFIT or MMEM:STOR:SYNT commands. This file type data

is embedded within the file.

MMEMory:LOAD:SYNThesis <FILENAME>

EXT[,<select_code>[,<unit _number>]]:

for <filename> restrictions)

OUTPUT 711;"mmemory:load:synthesis 'syfile.syn'"

OUTPUT 711;"MMEM:LOAD:SYNT 'INT:FILE1.fit'"

not applicable

Synchronization Required:

Preset State:

not applicable

SCPI Compliance:

instrument-specific