Calculate[1|2|3|4]:X:data?Query - Agilent Technologies 35670A Manual

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

CALCulate[1|2|3|4]:LIMit:STATe

Turns limit testing on and off for the specified trace.

Command Syntax:

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

When limit testing is on, the specified trace is evaluated against the limits defined in its upper and lower

limit registers. If a trace specifier is not used, the command defaults to trace A. You can load these

registers via the GPIB using the CALC:LIM:LOW:SEGM and the CALC:LIM:UPP:SEGM commands or

the CALC:LIM:UPP:TRAC and CALC:LIM:LOW:TRAC commands.

To determine whether or not a trace is within the specified limits, you can send the CALC:LIM:FAIL

query or monitor the bits in the Limit Fail condition register. (For more information, see "Limit Fail

To return failed points on the X-axis, send the CALC:LIM:LOW:REP and the CALC:LIM:UPP:REP

queries. To return failed points on the Y-axis, send the CALC:LIM:LOW:REP:YDAT and the

CALC:LIM:UPP:REP:YDAT queries.

Limit lines are not automatically displayed when limit testing is enabled. To display

limits you must send DISPlay[:WINDow[1|2|3|4]]:LIMt:STATe ON.

CALCulate[1|2|3|4]:LIMit:STATe OFF|0|ON|1

OUTPUT 711;":CALC2:LIM:STATE OFF"

OUTPUT 711;"calc:limit:stat ON"

CALCulate[1|2|3|4]:LIMit:STATe?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

command/query