Agilent Technologies 35670A Manual page 321

HCOPy[:IMMediate]
Plots or prints the currently specified item.
Command Syntax:
Example Statements:
Attribute Summary:
Description:
This command prints or plots only the item(s) specified with the HCOP:SOUR command. This command
is comparable to the front-panel [START PLOT/PRNT] softkey. Use the HCOP:DEST command to
specify where the print/plot operation is sent. Use the HCOP:DEV:LANG to specify the format of the
output.
Note
Pass Control Required if HCOP:DEST is 'SYST:COMM:GPIB:RDEV' (GPIB).
See "Passing Control" in chapter 3 of the GPIB Programmer's Guide for
information on how to pass control to the analyzer.
HCOPy[:IMMediate]
OUTPUT 711;"HCOPY"
OUTPUT 711;"hcop:imm"
Option: not applicable
Synchronization Required:
Preset State: not applicable
SCPI Compliance:
yes
approved
HCOPy
command
10-7