Agilent Technologies 35670A Manual page 395

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

MMEMory:LOAD:WATerfall

Loads a waterfall file into the analyzer from a file on the specified disk.

Command Syntax:

<FILENAME> ::= '[<PATH>]<filename>'

<PATH> ::= <MSIS>[{DOS_DIR}]

<MSIS> ::= RAM:|NVRAM:|INT:|

<DOS_DIR> ::= \<DIR_NAME>\

<DIR_NAME> ::= ASCII characters

<filename> ::= ASCII characters (see beginning of chapter

Example Statements:

Attribute Summary:

Description:

This command loads the contents of a file into one of the analyzer's eight waterfall registers (W1 through

W8). The file must have been saved with the MMEM:STOR:WAT command.

After loading the data register you can display its contents with the CALC:FEED 'W{1|2 . . . |8}'

Use the MMEM:LOAD:CONT if the file is saved on multiple disks. See the MMEM:LOAD:CONT

command for more information about loading split files on multiple disks.

MEMory:LOAD:WATerfall {W1|W2|W3|W4|W5|W6|W7|W8}, <FILE-

EXT[,<select_code>[,<unit _number>]]:

for <filename> restrictions)

OUTPUT 711;"MMEMORY:LOAD:WAT W8, 'INT:MYWAT'"

OUTPUT 711;"mmem:load:wat w3, 'testwat'"

not applicable

Synchronization Required:

Preset State:

not applicable

SCPI Compliance:

instrument-specific