Agilent Technologies 35670A Manual page 501

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

[SENSe:]SWEep:OVERlap

Specifies the maximum amount of time record overlap.

Command Syntax:

<number> ::= a real number (NRf data)

<unit> ::= [PCT]

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

Overlap processing is not used with triggered measurements. The analyzer must be in:

automatic arming (ARM:SOUR IMM)

frequency span  25.6 kHz (1 channel)

frequency span  12.8 kHz channel)

frequency span  6.4 kHz (4 channel)

(set with [SENSe:]FREQ:SPAN command)

continuous (free run) trigger mode (TRIG:SOUR IMM)

overload rejection off ([SENSe:]REJect:STATe OFF)

Data points from the end of one time record can be reused at the beginning of the next time record. This

results in the overlapping of time records. Use this command to specify the amount of the block size

which should be common to two consecutive time records.

[SENSe:]SWEep:OVERlap {<number>[<unit>]}|<step>|<bound>

OUTPUT 711;"sens:swe:overlap 52"

OUTPUT 711;"Swe:Overlap 26"

[SENSe:]SWEep:OVERlap?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

instrument-specific

command/query