Agilent Technologies 35670A Manual page 767

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

Comments for GETWATR

Determines where the program is running; either in the analyzer or on an external controller.

Specify interface select code and primary address for Instrument BASIC.

Specify analyzer's interface select code and primary address when the program is running on an

external computer. The specified primary address, 11, is the address set at the factory. If the

address for your analyzer has changed, edit the primary address to the appropriate value.

Allows device select code to be independent of address.

Reserve a large space for the frequency and amplitude data.

Reset the analyzer.

Set instrument mode to realtime octave analysis.

Specify 1/3 octave band measurement.

Specify 1/1 octave band measurement. Uncomment the statement (delete the "!") to specify this

type of measurement.

Specify 1/12 octave band measurement. Uncomment the statement (delete the "!") to specify this

type of measurement.

Example Programs