Input[1|2|3|4]:Reference:directioncommand/Query; Calculate[1|2|3|4]:Cfit:destinationcommand/Query - Agilent Technologies 35670A Manual

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

1. 1. Turn on the HP 9000 Series 340. If necessary, load BASIC following the instructions in the

computer's operating manual. Note that the following language extensions must be installed for the

verification program to work:

Programs that are more complex than the verification program will probably require more language

extensions. For a complete list of loaded language extensions, enter the following BASIC

command into your computer:

Turn on the Agilent 35670A. When the softkey labels appear, press the [ Local/GPIB ] hardkey.

See figure 1-2.

Verify that the analyzer's address is set to 11. The current address setting is displayed when you

press the [ ANALYZER ADDRESS ] softkey (see figure 1-3). You can change the address by pressing

[ ANALYZER ADDRESS ], then using the numeric keypad and the [ ENTER ] softkey to enter a new value.

However, the instructions in the verification procedure assume that the analyzer address is set to 11.

1-2. Agilent 35670A Front Panel