Agilent Technologies 35670A Manual page 759

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

20 !————————————————————————————————————-

30 ! BASIC/IBASIC Program; Time Capture Data Transfer

40 ! This program sets up a time capture measurement and

50 ! reads the time capture data into an array. The time

60 ! capture data is then modified and put back into the

70 ! capture buffer.

90 ! NOTE: Connect the Agilent 35670A Source output to the

100 ! Channel 1 input before running this program.

110 !————————————————————————————————————

130 DIM Y(1:100,1:1024)

150 IF POS(SYSTEM$("SYSTEM ID"),"Agilent 35670") THEN

210 ASSIGN @Analyzer TO Address

220 ASSIGN @Analyzer_bin TO Address;FORMAT OFF

250 OUTPUT @Analyzer;"SYST:PRES"

260 OUTPUT @Analyzer;"VOLT1:RANG 2 VPK"

270 OUTPUT @Analyzer;"OUTP ON"

280 OUTPUT @Analyzer;"SOUR:VOLT 2 VPK"

290 OUTPUT @Analyzer;"SOUR:FREQ 100 HZ"

300 OUTPUT @Analyzer;"CALC:FEED 'TCAP 1'"

310 OUTPUT @Analyzer;"DISP:WIND1:TRAC:Y:TOP 5; PDIV 1"

320 OUTPUT @Analyzer;"TCAP"

340 OUTPUT @Analyzer;"*OPC?"

350 ENTER @Analyzer;Opc

380 OUTPUT @Analyzer;"FORM REAL,64"

400 OUTPUT @Analyzer;"SENSE:DATA? TCAP1"

410 ENTER @Analyzer USING "%,A,D";Resp$,I

420 ENTER @Analyzer USING "%,"&VAL$(I)&"D";Bytes

440 Points=Bytes/8

450 Records=Points/1024.

Program listing continues on page F-23

Example Programs