Agilent Technologies 35670A Manual page 505

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

[SENSe:]SWEep:TIME

Specifies the length of the time record in seconds.

Command Syntax:

<number> ::= a real number (NRf data)

<unit> ::= [S]

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

When you send this command, two other values may be adjusted. The value of the frequency span

(FREQ:SPAN) is adjusted to FREQ:RES / record length (in hertz). If the start frequency is "fixed"

(FREQ:SPAN:LINK STAR), the center and stop frequencies are adjusted accordingly. If the center

frequency is "fixed" (FREQ:SPAN:LINK CENT), the start and stop frequencies are adjusted.

If you change the frequency span, the time record length is adjusted to:

In correlation analysis instrument mode (INST:SEL CORR):

This command specifies the record length, T.

collected. T is used in correlation windowing functions as follows:

The record length, T, is independent of the frequency resolution (FREQ:RES). Changing the value

of one does not change the value of the other. See the online help for additional information about

record length in correlation analysis.

[SENSe:]SWEep:TIME {<number>[<unit>]}|<step>|<bound>

976.5625e-6:8192.0

OUTPUT 711;"SWE:TIME 1 S"

OUTPUT 711;"sense:sweep:time 3.125e-2"

[SENSe:]SWEep:TIME?

not applicable

Synchronization Required:

Preset State:

+7.8049E-003

SCPI Compliance:

T represents the length of the raw time record

command/query