Agilent Technologies 35670A Manual page 288

DISPlay
DISPlay[:WINDow[1|2|3|4]]:TRACe:Y:MATCh[1|2|3|4]
Modifies the Y-axis scaling of a trace to match the Y-axis scaling of the reference trace.
Command Syntax:
Example Statements:
Attribute Summary:
Description:
This command modifies the scaling of the Y-axis of the trace selected with the [:WINDow[1|2|3|4]] trace
specifier to match the Y-axis scaling of the reference trace. The MATCH[1|2|3|4] trace specifier selects
the reference trace. Omit the specifier or use 1 for trace A, 2 for trace B, 3 for trace C, and 4 for trace D.
The Y-axis of both traces must be compatible. Scaling of the Y-axis is specified with the
CALCulate:FORMat command. The following coordinate systems are compatible:
Linear magnitude for both traces (CALC:FORM MLIN).
Linear magnitude data on a logarithmic Y-axis for both traces (CALC:FORM
MLIN;DISP:TRAC:Y:SPAC LOG).
Logarithmic magnitude for both traces (CALC:FORM MLOG).
Phase (wrapped or unwrapped) for both traces (CALC:FORM PHAS or CALC:FORM UPH).
Numbers (real or imaginary) for both traces (CALC:FORM REAL or CALC:FORM IMAG).
Nyquist diagram for both traces (CALC:FORM NYQ).
Polar plots for both traces (CALC:FORM POL).
If the trace formats are not compatible the Y-axis is not modified.
8-34
DISPlay[:WINDow[1|2|3|4]]:TRACe:Y:MATCh[1|2|3|4]
OUTPUT 711;":DISP:WIND2:TRAC:Y:MATCH1"
OUTPUT 711;"display:window4:trac:y:match3"
Option: not applicable
Synchronization Required:
Preset State: not applicable
SCPI Compliance:
no
instrument-specific
command