Agilent Technologies 35670A Manual page 363

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

INSTrument[:SELect]

Selects one of the analyzer's six major instrument modes.

Command Syntax:

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

The following commands select a major instrument mode:

INST:SEL CORR – Correlation Analysis

INST:SEL FFT – FFT Analysis

INST:SEL HIST – Histogram

The following commands are valid if the appropriate option is installed:

INST:SEL OCT – Octave Analysis – Option 1D1

INST:SEL ORD – Order Analysis – Option 1D0

INST:SEL SINE – Swept Sine – Option 1D2

The GPIB command set changes with each instrument mode. Parameters sent to setup a measurement for

each instrument mode do not affect setups for other instrument modes. As a result, you should select the

instrument mode near the beginning of any program sequence that defines the instrument state.

INSTrument[:SELect] FFT|OCTave|ORDer|SINE|HISTo-

gram|CORRelation

OUTPUT 711;":Inst SINE"

OUTPUT 711;"INST:SELECT FFT"

INSTrument[:SELect]?

FFT|OCT|ORD|SINE|HIST|CORR

1D0 Computed Order Tracking

1D1 Realtime Octave

1D2 Swept Sine

Synchronization Required:

Preset State:

SCPI Compliance:

command/query