Agilent Technologies 35670A Manual page 362

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

INSTrument:NSELect

Selects one of the analyzer's six major instrument modes.

Command Syntax:

<number> ::= a real number (NRf data)

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

The following commands select a major instrument mode:

INST:NSEL 0 – FFT Analysis

INST:NSEL 4 – Histogram

INST:NSEL 5 – Correlation Analysis

The following commands are valid if the appropriate option is installed:

INST:NSEL 1 – Octave Analysis – Option 1D1

INST:NSEL 2 – Order Analysis – Option 1D0

INST:NSEL 3 – Swept Sine – Option 1D2

The GPIB command set changes with each instrument mode. Parameters sent to setup a measurement for

each instrument mode do not affect setups for other instrument modes. As a result, you should select the

instrument mode near the beginning of any program sequence that defines the instrument state.

The default instrument mode is FFT at powerup and reset.

INSTrument:NSELect <number>|<bound>

OUTPUT 711;"INST:NSELECT 4"

OUTPUT 711;"inst:nselect 4"

INSTrument:NSELect?

1D0 Computed Order Tracking

1D1 Realtime Octave

1D2 Swept Sine

Synchronization Required:

Preset State:

SCPI Compliance:

command/query