Agilent Technologies 35670A Manual page 96

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

Stops the current measurement in progress.

Command Syntax:

Example Statements:

Attribute Summary:

Description:

This command aborts any measurement in progress and resets the trigger system. ABOR forces the

trigger system to an idle state. ABORt forces the Measuring bit (bit 4) and the Averaging bit (bit 8) of the

Operation Status register to 0. To restart a measurement you must send the INIT:IMM command.

The program message ABOR;:INIT:IMM serves a special synchronization function. When you send this

message to restart a measurement, the analyzer's No Pending Operation (NPO) flag is set to 1 until the

measurement is complete. The two commands that test the state of this flag—*WAI and *OPC—allow

you to hold off subsequent actions until the measurement is complete. See chapter 3 of the GPIB

Programmer's Guide for more information about synchronization.

When averaging is on ([SENSe:]AVERage[:STATe] ON) the NPO flag is not set to 1

until n measurements have been combined into one trace. You specify the value of n

with the[SENSe:] AVER:COUNt command.

OUTPUT 711;"abor"

OUTPUT 711;"Abort"

not applicable

Synchronization Required:

Preset State:

not applicable

SCPI Compliance: