Agilent Technologies 35670A Manual page 487

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

[SENSe:]FREQuency:STOP

Sets the stop frequency to the specified value.

Command Syntax:

<number> ::= a real number (NRf data)

<unit> ::= [HZ|CPM]

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

In FFT analysis instrument mode (INST:SEL FFT):

This command defines the upper limit of the frequency bandwidth. The start frequency remains

fixed (FREQ:SPAN:LINK). The values for the center frequency, the frequency span, and the record

length change to appropriate values.

In octave measurement mode (INST:SEL OCT; Option 1D1):

This command specifies the stop frequency for the octave measurement. The frequency can be

specified in Hz or as a band number.

In swept sine instrument mode (INST:SEL SINE; Option 1D2):

The value specified by this command is rounded to the next higher 15.625 mHz step. The start

frequency (FREQ:STAR) is held constant and selected as the new "anchor" for the measurement.

The center frequency and frequency span are adjusted to appropriate values.

[SENSe:]FREQuency:STOP {<number>[<unit>]}|<step>|<bound>

0.03125:115000.0

OUTPUT 711;"SENS:FREQ:STOP 25.6 KHZ"

OUTPUT 711;"frequency:stop max"

[SENSe:]FREQuency:STOP?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

command/query