Agilent Technologies 35670A Manual page 515

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

[SENSe:]TCAPture:TACHometer:RPM:MAXimum

Specifies the tachometer's maximum RPM when included in the time capture

buffer.$Itachometer;maximum RPM in time capture

Command Syntax:

<number> ::= a real number (NRf data)

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command sets the upper limit of the rotation speed range you want to monitor for measurements

using the time capture buffer.

In a runup measurement, this value specifies when the measurement stops. In a rundown measurement,

this value specifies when the measurement starts.

This command is not used when the analyzer is in order analysis (INST:SEL ORD;

Option 1D0). The analyzer's tachometer is always ON in this instrument mode. Specify

the tachometer's maximum RPM with the [SENSe:]ORDer:RPM:MAXimum command

when the analyzer is in order analysis instrument mode.

To include the tachometer input signal in the time capture buffer, send the

TCAPture:TACHometer[:STATe] command.

The value specified with this command is used by the analyzer to allocate memory for

the tachometer buffer. If the value specified is too low, the analyzer aborts the time

capture when it fills the tachometer buffer.

[SENSe:]TCAPture:TACHometer:RPM:MAXimum <number>|

OUTPUT 711;":TCAPTURE:TACH:RPM:MAXIMUM 193783"

OUTPUT 711;"sens:tcapture:tach:rpm:maximum 275254"

[SENSe:]TCAPture:TACHometer:RPM:MAXimum?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

instrument-specific

command/query