Agilent Technologies 35670A Manual page 558

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

STATus:DEVice:PTRansition

Sets and queries bits in the Device State positive transition register.

Command Syntax:

<number> ::= a real number (NRf data)

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

To set a single bit in the Device State positive transition register to 1, send the bit's decimal weight with

this command. To set more than one bit to 1, send the sum of the decimal weights of all the bits. (The

decimal weight of a bit is 2

All bits are initialized to 0 when the analyzer is turned on or when the STAT:PRES command is sent.

However, the current setting of bits is not modified when you send the *RST command.

See "Device State Register Set" in chapter 1 for a definition of bits in the register set. See "Programming

the Status System" in the GPIB Programmer's Guide for information about the role of positive

transition registers in register sets.

STATus:DEVice:PTRansition <number>|<bound>

OUTPUT 711;"status:dev:ptransition 17"

OUTPUT 711;"stat:dev:ptr 20"

STATus:DEVice:PTRansition?

not applicable

Synchronization Required:

Preset State:

not affected by Preset

SCPI Compliance:

, where n is the bit number.)

instrument-specific

command/query