Agilent Technologies 35670A Manual page 638

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

TRIGger:LEVel

Specifies the level of the input signal which causes the analyzer to trigger.

Command Syntax:

<number> ::= a real number (NRf data)

<unit> ::= [PCT|V|VPK|EU]

<step> ::= UP|DOWN

<bound> ::= MAX|MIN

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

You can specify the trigger level as a value, as a percentage of the trigger channel's current input range,

or as a fraction of the trigger channel's current input range. TRIG:LEV 0.25 is the same as TRIG:LEV 25

To query the analyzer's current input range, send [SENSe:]VOLT[1|2|3|4]:RANG?. To determine the

units, send VOLT[1|2|3|4]:RANG? UNIT.

The trigger source must be one of the analyzer's four input channels, TRIG:SOUR INT1, TRIG:SOUR

INT2, TRIG:SOUR INT3, or TRIG:SOUR INT4.

TRIGger:LEVel {<number>[<unit>]}|<step>|<bound>

-9.9e37:9.9e37

OUTPUT 711;"TRIGGER:LEV .10"

OUTPUT 711;"trig:lev -50 PCT"

OUTPUT 711;"TRIGGER:LEVEL 2.5 V"

TRIGger:LEVel?

not applicable

Synchronization Required:

Preset State:

SCPI Compliance:

command/query