Agilent Technologies 35670A Manual page 386

MMEMory
MMEMory:LOAD:DTABle:TRACe[1|2|3|4]
Loads a data table into the analyzer from a file on the specified disk.
Command Syntax:
<FILENAME> ::= '[<PATH>]<filename>'
<PATH> ::= <MSIS>[{DOS_DIR}]
<MSIS> ::= RAM:|NVRAM:|INT:|
<DOS_DIR> ::= \<DIR_NAME>\
<DIR_NAME> ::= ASCII characters
<filename> ::= ASCII characters (see beginning of chapter
Example Statements:
Attribute Summary:
Description:
The trace specifier selects which trace you are loading the data table into—TRAC1 for trace box A,
TRAC2 for trace box B, TRAC3 for trace box C, and TRAC4 for trace box D. The parameter specifies
the disk and filename. If the disk is not specified, the file is loaded from the default disk.
The file must have been saved with the MMEM:STOR:DTABle command.
15-12
MMEMory:LOAD:DTABle:TRACe1|2|3|4}, <FILENAME>
EXT[,<select_code>[,<unit _number>]]:
(DOS only)
for <filename> restrictions)
OUTPUT 711;"mmem:load:dtab:trac2, 'int:testdtab'"
OUTPUT 711;"MMEM:LOAD:DTAB:TRAC1, 'MYTABLE'"
Option: not applicable
Synchronization Required:
Preset State: not applicable
SCPI Compliance:
no
instrument-specific
command