Agilent Technologies 35670A Manual page 255

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

This subsystem contains commands that control the analyzer's presentation of data on its front-panel

The DISPlay subsystem contains commands grouped under the WINDow keyword. The WINDow

keyword contains an optional trace specifier: [1|2|3|4]. To direct a command to trace A, omit the

specifier or use WIND1. To direct a command to trace B, use WIND2; to trace C, use WIND3; and to

trace D, use WIND4.

WINDow is an implied mnemonic. Therefore, you can omit it from DISPlay commands. However, if

you wish to direct a DISPlay command to a specific trace box, you must use the WINDow trace specifier.

See "Implied Mnemonics" in chapter 2 of the GPIB Programmer's Guide for more information.