Agilent Technologies 35670A Manual page 591

Dynamic signal analyzer gpib programming

Hide thumbs Also See for 35670A:

Table of Contents

SYSTem:COMMunicate:SERial[:RECeive]:PACE

Sets the RS-232-C receiver handshake pacing type.

Command Syntax:

Example Statements:

Query Syntax:

Return Format:

Attribute Summary:

Description:

This command specifies the type of handshake the analyzer uses when it is receiving data.

XON specifies the XON/XOFF protocol. The analyzer sends XOFF (DC3, decimal code 19) to the

peripheral to stop the transmission of data. When it is able to receive additional data, the analzyer sends

XON (DC1, decimal code 17) to the peripheral, which then resumes transmitting data. This software

handshake is the easiest to implement.

NONE specifies the absence of a handshake protocol for pacing.

Check the documentation for your peripheral device to verify it supports the specified protocol.

SYSTem:COMMunicate:SERial[:RECeive]:PACE NONE|XON

OUTPUT 711;"SYST:COMM:SER:REC:PACE XON"

OUTPUT 711;"system:comm:serial:pace none"

SYSTem:COMMunicate:SERial[:RECeive]:PACE?

not applicable

Synchronization Required:

Preset State:

not affected by Preset

SCPI Compliance:

command/query