Agilent Technologies 35670A Manual page 471

In swept sine instrument mode (INST:SEL SINE; Option 1D2):
If linear spacing is specified (SWE:SPAC LIN), the resolution can be set using the following units:
HZ hertz
–
PNT/SWP points per sweep
–
PCT spacing between measurement points as a percentage of the total frequency span
–
If logarithmic spacing is specified (SWE:SPAC LOG), the resolution can be set using the following
units:
PNT/SWP points per sweep
–
PNT/DEC points per decade
–
PNT/OCT points per octave
–
PCT spacing between measurement points as a percentage of the total frequency span
–
To determine what the current unit setting is, send FREQ:RES? UNIT. See table 18-4 to determine
the number of displayed data points with swept sine variable resolution.
Note
This command is not used in swept sine if the FREQ:RES:AUTO ON command is sent.
1
The spacing of measurement points in hertz is equal to FREQ:SPAN / FREQ:RES (PNT/SWP).
PCT, the spacing between measurement points is a percentage of the total frequency span.
1
)
[SENSe:]
With
18-33